NewYall Pack of 6 Ignition Coil Connector Plug Harness Replace 90980-11885 for Chevrolet Prizm 2000-2002 Pontiac Vibe 2003-2010 Scion tC 2005-2010 Scion xB 2004-2006 2008-2015 Lexus Toyota 1998-2017

Had to change the ignition coil on my rav4 recently and broke the connector. Ordered these and they are a perfect fit. I did not splice the wires but removed the pigtail from this one and the car and attached the wires into this one. There are youtube videos to help with doing that. Its easy once you figure out how to do it. Remove the white protective plastic, use a really small precision philips to press down on a black tab under the pigtail while pulling the wire at the back. No force is require, just ease out the wires. Do the same on the broken connector on the car and fix the wires one by one into the new connector, making sure of the order or the wires. Best to take out one and put it in the same position in the new connector and then move on to the next. Taking a picture beforehand would be great. It takes less than 10 mins to replace the connector. Absolutely recommend these if the connector tab breaks while replacing/checking ignition coils.

If your Toyota has the often broken locking tabs on the connector that attaches to the ignition coils then this is a cheap and easy fix requiring only a 1/16" jeweler's screwdriver. You will receive six connectors for around $14.00. Toyota charges $8-11.00 each for one (90980-11855.) There is no need to splice any wires--just replace the damaged connector housing. Simply pry downward on the small tab below each of the four terminals and push the metal terminals out of the rear. Firmly press the terminals back into the new connector (keep the colored wires in the same order as before removal) and reattach to each ignition coil.

Nice replacement for Toyota's ignition coil connectors works as should.

When my 2006 Avalon started misfiring, I knew I needed coil packs. This is a common thing. Another common thing is that the coil connectors disintegrate at the connector. Soldered these in and fit perfectly snug.

I am satisfied with this item.

So I was a little worried about splicing part of the ignition system. Turns out it wasn't a big deal. You could strip the wires out with a paper clip. There is a notch on the white retainer that can be popped out then there are little clips holding the wires in. you can push a pin or small screw driver in and lift releasing the wire. Then you can move the connectors from the old connector. Worked like a champ on my wife's 2005 4 cylinder Camry. After figuring out the process to disassemble one, I was able to finish all 4 in about 20 minutes. No splicing necessary.

Very happy with purchase. Watched You-Tube for installation. No need to splice if wiring is in good shape.

I woke up to my Lexus engine with a miss fire, the app told me it was number six cylinder. I opened the hood, and removed all the "beauty covers" to find that a chipmunk had created a feeding station there and managed to chew through the ignition coil wires for that one cylinder.These connectors are a direct fit, not a factory replacement, but close enough.You will receive a package of six. The wire leads have thicker gauge wire that stock.All in all a great value

I have a Highlander 2018 XLE. A mouse damaged the wires of one of the Ignition Coil Connectors. Many Toyota dealers said Toyota sells the whole engine harness only for thousands of dollars plus labor. A couple of dealers wanted to sell me one connecter with the 4 wires for $120.00 - $220.00. At Amazon, I get 6 connectors with wires for $29.00. Check Amazon before you buy anything.